Winter 2023Project

Spinning Lite-Brite Globe

I have a globe that's somehow followed me around since childhood - it was never particularly good (the hemispheres don't perfectly align along the seam - ugh!) but my heart yearns for a fellow survivor. I knew there'd be a project for it some day, and I finally figured out what to do with it - make it a fun dynamic "art" piece representing where I've been!

The Plan

Stick a bright light inside, poke holes in the places I've been - light comes out makes twinkly. Neato. Dynamic it up by sticking it on a motor, and get it to go real slow, like a clean fraction of its actual 24h rotation speed.

Step 1 - Do everything all at once

I really didn't follow a step-by-step process here, I just started digging in, flipping between pieces every time I felt stuck or bored with something else. So let's break this one into functional pieces.

Lighting

I wanted to install lights inside the globe, and have them be a somewhat consistent brightness across the whole surface (i.e. no dots that are noticeably brighter/dimmer on the outside). I briefly thought about silvering the insides with tinfoil, but settled on some cheap paint - to be honest I thought it would be better stuff than "glue with lots of glitter" but here we are. I painted the insides with a few coats, and figured I'd revise based on how the final piece looked.

SplitEarther

Since I knew out of the gate that I wanted this piece to be in motion, I was overjoyed to finally have a reason to buy inductive power transfer modules. These are just coils of wire that sit near each other and wirelessly transfer power, like wireless phone charging. I used a flanged coupling connector and some 3D printing to make it look spiffy.

MountingTheInductionCoil     InsideTheInductionCoil

To test things out, I connected a small strip of white LEDs, and sure enough, when the globe is coupled to the motor, power is transferred and it can still freely spin!

TestLights     TestLightsPowered

After some testing with a flashlight, I determined that just punching holes through the globe wasn't going to cut it, light would come through faintly and with a very limited viewing angle. So I ordered some small light pipes that fit perfectly into the hole created by a pushpin.

Even with that solution, these test lights weren't bright enough at all.

NoLight

So, I threw in every bright white light I had to spare - scraps from many different projects. It's a hodgepodge, but who's going to know? Tell no one. The results are much better!

AlTheLEDs     AlTheLEDsPowered

MuchBrighter     MuchBrighter

MuchBrighter     MuchBrighter

Motor & Mounting

Initially I thought a stepper motor would be perfect for this project - it's semi-precise with good torque and speed control. Early tests showed I wasn't wrong, but the stepping motion wasn't smooth, and made an annoying knocking sound.

Stepper     AGoodCleanMount

After much effort to get the stepper to be smoother, I decided to explore a regular DC gear motor, and found a low-profile 3RPM motor on Amazon that turned out to be a much better fit.

Putting it all together

For my last trick, I wanted to tilt the globe at the same angle as our axial tilt (23.5°). I 3D printed a base that did just that, and brought the coils closer together for better power transfer / less heat loss.

ZipTieLife     PowerConnections

Smooth spinning, the correct direction of rotation, and consistent lighting - win! Now time to get to work with the thumbtack to add more places!

Shopping List