Bluetooth Phone
A friend of mine saw the StoryPhone and wondered if I could do something fun with the "vintage" style phone she has. After some creative brainstorming, I took on the challenge of making this into a Bluetooth "headset" - aka you can pair it with your phone, and when your phone rings, it rings and you can pick up the handset and have the call. You can also use it as a crappy Bluetooth speaker, and I loaded all the keys with sound effects for good measure.
Unfortunately for us all, I pulled a "surely I'll always remember how this went together" and didn't write anything down at the time. Here's a block diagram I put together from staring at the pictures, code, and my Amazon order history:
The Rocker Switch
I started by gutting the existing phone back to its peripheral connections. The rocker switch went with it as it was part of the core circuit board. It wasn't elegant, but a poor 3D print and an arcade switch later, I had something that consistently worked well.
The Ringer
Perhaps most disappointingly, this low-cost phone didn't include a great set of bells and a ringer. I love that proper ringing sound. Thoroughly discouraged, I used the parts I had on hand to drive the existing integrated bell-solenoid.
Note that a normal telephone signal will drive the ringer at 90+ volts - that's challenging to achieve without building something specific, and I was keeping this cheap and cheerful. I used a cheap boost converter set to the max output to drive the solenoids with middling results.
First I tried straight relays to drive it, figuring this may produce the loudest results:
It did, but it came with a lot of distracting clunking from the solenoid and clicking from the relays, so I decided to go to a solid-state PWM solution. I had a simple DC motor driver on hand, so I gave that a shot:
A little fainter, but a much nicer, cleaner sound. I decided to send it, and packaged it back up inside the phone.
The Rest
The general idea I had was to take an off-the-shelf Bluetooth adapter with an integrated mic and a headphone output, and basically connect the existing phone handset to it, effectively turning it into a giant speakerphone unit.
Using a Raspberry Pi Pico controller as a base, I first integrated the keypad to it using the Adafruit Keypad library for easy decoding. I then used a separate SoundFX module over a Serial connection to play effects. This module shows up as a small storage drive when plugged into a computer, so I plumbed its USB connection out the back of the phone - that way my friend can swap in her own effects.
Then came the tricky part - I had small speakers that I wanted to play while the phone was on the rocker, but if the handset was picked up, I wanted it to switch to the handset speaker. While I wanted this functionality to live independently of the microcontroller, it ultimately made the most sense to integrate it all to be able to more seamlessly transition between different states (handset up/down, call vs music, keypad effect vs phone connection, etc.).
So this is where it gets hard to write out in a linear way - I kept iterating on the different components until it all started working the way I expected.
Putting It All Together
Once I felt reasonably convinced I had all the pieces I needed to make this work, and wiring felt final enough, it was time to stick it all together with VHB.
My friend loved her very bespoke gift, and I got an excuse to be elbow-deep in a telephone again, so everybody wins!
Shopping List
- Cheap Arcade Switch [Amazon]
- Cheap Boost Converter [Amazon]
- Adafruit DRV8871 DC Motor Driver [Digi-Key] [Mouser]
- Adafruit Audio FX Mini Sound Board [Digi-Key] [Mouser]
- Raspberry Pi Pico [Digi-Key] [Mouser]
- Cheap Audio Amp [Amazon]
- Cheap Bluetooth Receiver [Amazon]
- Cheap Relay Module [Amazon]